However, don’t use an auto cat feeder as an excuse not to find cat sitters, walkers, or boarding facilities for your kitty when you travel. Cats have a reputation for independence and appear not to need the same affection, attention, and love as other household pets. Pour in the food, and it’s ready for your cat.Īs much as automatic cat feeders make taking care of a cat easier, responsible cat owners shouldn’t use them as substitutes for human connection. Tape or glue the folded cardboard where the two bottles connect. Heil, R., McCarthy, K., Rege, F., Rodriguez-Carlson, A.: The Smart Pet Feeder: A Proposal to Design and Build an Automated Pet Feeder Capable of Preventing. Step 7: Fold the cardboard to a suitable size, depending on the size of your bottle, to make a platform. Build an Automatic Pet Feeder Stick to an automated dry food schedule with this helpful build from russo08 on Hackster.It would be best if you made a lid that you can close the mouth with, to prevent the food from pouring out if the cat knocks down the feeder. This hole will allow you to pour in cat food. Step 6: Cut a hole at the first bottle’s top, removing the bottle top to widen the mouth.Your kitty will use this hole to access the food. Step 5: Cut a dispensing hole near the second bottle’s top.Step 4: Stick two bottles together using tape or hot glue to hold them in place.The first bottle should be standing, with the second lying horizontally on the floor, acting as the cat’s feeding station or bowl. Step 3: Fit the two bottles together at the cutouts.This will help the two bottles slip in together nicely. Step 2: For the second bottle, cut a hole on the side, just near the bottom.It has a tamper-proof lid, and the kibble chamber and feeding tray are dishwasher safe. This timed pet feeder allows you to remotely set up to four feedings per day and control portion sizes from 1 to 10 portions per meal (each portion is 24ml). The servo will be glued to one end of the plastic bottle, and rotate a piece of cardboard small enough to close the opening of the bottle so that the dry food is blocked. Connect the servos VCC and GND pins to 5V VCC and GND on the Arduino. Almost half of the bottom should be cut out. The Arf Pets automatic dog food dispenser is another smart, WiFi-enabled feeder. Connect the servos signal pin to pin 9 on the Arduino.

Step 1: First off, take the first bottle and cut a hole at its bottom.

Build automatic dog feeder